|
Driveline bent
|
Contact with drawbar.
|
Reposition drawbar. (See Preparing the Tractor section.)
|
|
|
Contact with frame.
|
Shorten center link. (See ADJUSTING CUTTING HEIGHT/TAILWHEEL POSITION in Operating the Cutter section.)
|
|
|
Too long, bottoms out.
|
See your John Deere dealer.
|
|
Telescoping tube fails
|
Shock load.
|
Avoid solid objects.
|
|
Telescoping tube wears
|
Short tube engagement.
|
See your John Deere dealer.
|
|
|
Lack of lubrication.
|
Apply grease daily. (See Lubrication and Maintenance section.)
|
|
Yoke or cross fails
|
Lack of lubrication
|
Apply grease daily. (See Lubrication and Maintenance section.)
|
|
|
Shock load.
|
Avoid solid objects.
|
|
|
Slip clutch seized caused driveline to receive high shock loads.
|
Inspect clutch linings and repair or replace as necessary. (See your John Deere dealer.)
|
|
Twisted
|
Slip clutch seized caused driveline to receive high shock loads.
|
Inspect clutch linings and repair or replace as necessary. (See your John Deere dealer.)
|