|
Uneven cut
|
Travel speed too fast.
|
Reduce travel speed.
|
|
|
Bent blades.
|
Replace. (See REPLACING BLADES in Service section.)
|
|
|
Bent blade holder.
|
Replace. (See your John Deere dealer.)
|
|
|
Cutter not level side-to-side.
|
Adjust tractor lift links. (See ADJUSTING CUTTING HEIGHT/TAILWHEEL POSITION in Operating the Cutter section.)
|
|
|
Improper height adjustment.
|
Adjust cutting height. (See ADJUSTING CUTTING HEIGHT/TAILWHEEL POSITION in Operating the Cutter section.)
|
|
|
Low tractor tire pressure on one side.
|
Adjust tire pressure. (See your tractor Operator's manual.)
|
|
|
Turning too fast.
|
Reduce ground speed while turning.
|
|
|
Blades worn, dull, or bent.
|
Replace blades. (See REPLACING BLADES in Service section.)
|
|
|
Tractor tires push grass down.
|
Adjust tractor wheel spacing. (See your tractor Operator's manual.)
|
|
|
Grass too wet.
|
Wait for grass to dry.
|
|
Poor shredding
|
Excessive ground speed.
|
Reduce ground speed.
|
|
|
Incorrect cutting height setting.
|
Adjust cutting height. (See ADJUSTING CUTTING HEIGHT/TAILWHEEL POSITION in Operating the Cutter section.)
|