Removing and Installing PTO Driveline-MX5 and MX6

1. Disconnect chain (C). 2. Remove two quick-lock pins (B) and raise PTO shield (A).


A-PTO Shield
B-Quick-Lock Pin (2 used)
C-Chain

W05658

AG,OUO1078,363 -19-28JAN00-1/2

NOTE: Driveline removed for illustration purposes.

3. Pull locking collar (A) toward slip clutch.

4. Remove driveline assembly from gear case input shaft.

5. Make repairs as necessary:

  • Slip clutch service-See DISASSEMBLING AND INSPECTING SLIP CLUTCH-MX5 and MX6 in this section.
  • Driveline repair-See your John Deere dealer.

IMPORTANT: Apply multipurpose grease on gear case input shaft.

6. Install driveline in reverse order of removal.


A-Locking Collar

W03709

AG,OUO1078,363 -19-28JAN00-2/2