Removing and Installing PTO Driveline-MX7

1. Disconnect chain (C).

2. Remove two quick-lock pins (B) and raise PTO shield (A).


A-PTO Shield
B-Quick-Lock Pin (2 used)
C-Chain

W03688

AG,OUO1078,364 -19-28JAN00-1/2

NOTE: Driveline removed for illustration purposes.

3. Remove lock nut (C) and washer (B).

4. Remove tapered pin (A) using a brass drift and hammer.

5. Remove driveline assembly from gear case input shaft.

6. Make repairs as necessary:

  • Slip clutch service-See DISASSEMBLING AND INSPECTING SLIP CLUTCH-MX7 in this section.
  • Driveline repair-See your John Deere dealer.

7. Install driveline in reverse order of removal using the following special instructions:

  • Apply multipurpose grease on gear case input shaft.
  • Align hole in hub with groove in input shaft and install tapered pin, washer and lock nut. Install tapered part of pin facing groove around input shaft. Tighten lock nut to specifications.

Specification

Tapered Pin Lock Nut -Torque 150 N·m (110 lb-ft)
W03703


A-Tapered Pin
B-Washer
C-Lock Nut

AG,OUO1078,364 -19-28JAN00-2/2