Replacing Skid Shoes

causym CAUTION: When servicing skid shoes, it will be necessary to work underneath cutter. Before servicing cutter, refer to PRACTICE SAFE SERVICE PROCEDURES at the beginning of this section.

Avoid potentially toxic fumes and dust. Hazardous fumes can be generated when paint is heated by welding, soldering, grinding, or using a torch. Refer to REMOVE PAINT BEFORE WELDING OR HEATING in Safety section.

1. Lower cutter onto safety shop stands.

TS261

AG,OUO1078,368 -19-28JAN00-1/2

NOTE: Skid shoes (A) are welded on.

2. Remove existing skid shoe with a grinder.

3. Weld on a new skid shoe.

4. Apply green John Deere paint to exposed metal areas.

5. Raise cutter and remove safety stands.

6. Lower cutter to the ground.


A-Skid Shoe

W03694

Skid Shoe-Left-Hand Side Shown

AG,OUO1078,368 -19-28JAN00-2/2