Install PTO Driveline-MX7

1. Remove lock nut (C), washer (B) and tapered pin (A) from slip clutch hub.


A-Tapered Pin
B-Washer
C-Lock Nut

W03703

AG,OUO1078,384 -19-09FEB00-1/5

2. Remove two quick-lock pins (B) and raise PTO shield (A).

3. Remove paint from gear case input shaft using a wire brush.

4. Apply multipurpose grease on input shaft.

5. Align splines of slip clutch hub with gear case input shaft and slide hub onto shaft.


A-PTO Shield
B-Quick Lock Pin (2 used)

W03687

AG,OUO1078,384 -19-09FEB00-2/5

6. Align hole in hub with groove in input shaft and install tapered pin, washer and lock nut (A). Install tapered part of pin facing groove around input shaft. Tighten lock nut to specifications.

Specification

Tapered Pin Lock Nut -Torque 150 N·m (110 lb-ft)

7. Lower PTO shield and install quick-lock pins.


A-Lock Nut

W03720

AG,OUO1078,384 -19-09FEB00-3/5

8. Attach chain (A) at location shown.


A-Chain

W05666

AG,OUO1078,384 -19-09FEB00-4/5

NOTE: Driveline is shipped with a screw (A) installed to prevent driveline from extending.

9. Remove screw and tag.


A-Screw

W03713

AG,OUO1078,384 -19-09FEB00-5/5