|
1.
Store cutter on blocks to allow air circulation under deck.
2.
Put cutter in a dry place.
3.
Clean cutter thoroughly. Trash and dirt will draw moisture and cause rust.
4.
Lubricate complete machine. (See Lubrication and Maintenance section.)
5.
Check condition of blades. Replace as necessary.
6.
Check for loose or missing hardware.
7.
Paint all parts where necessary.
|
8.
Keep PTO driveline off ground. Attach to top of hitch/mast or remove front half and store indoors.
IMPORTANT:
After long idle periods, linings of slip clutch may draw moisture. Linings may bond to metal parts causing slip clutch to be ineffective. Loosen all lock nuts on slip clutch. This will relieve spring load on the disks reducing this problem during storage.
9.
Loosen lock nuts on slip clutch.
10.
List replacement parts needed and order them early from your John Deere dealer.
|