Install PTO Driveline-MX5 and MX6

1. Remove two quick-lock pins (B) and raise PTO shield (A).

2. Remove paint from gear case input shaft using a wire brush.

3. Apply multipurpose grease on input shaft.


A-PTO Shield
B-Quick Lock Pin (2 used)

W05665

OUO6077,0001600 -19-19AUG02-1/4

4. Pull locking collar (A) toward slip clutch.

5. Align splines of slip clutch hub with gear case input shaft and slide hub onto shaft until locking collar snaps into place.

6. Lower PTO shield and install quick-lock pins.


A-Locking Collar

W03709

OUO6077,0001600 -19-19AUG02-2/4

7. Attach chain (A) at location shown.


A-Chain

W03721

MX5 Shown

OUO6077,0001600 -19-19AUG02-3/4

NOTE: Driveline is shipped with a screw (A) installed to prevent driveline from extending.

8. Remove screw and tag.


A-Screw

W03713

OUO6077,0001600 -19-19AUG02-4/4