|
IMPORTANT:
Operating loader with loose mounting frames will cause damage. Tightening mounting frame hardware to specified torque at initial installation is critical.
Hardware torque MUST be checked after the first 10 hours and every 50 hours thereafter.
1.
Tighten mounting frame hardware. (See FIRST 10 AND EVERY 50 HOURS in Lubrication and Maintenance section.)
|
2.
Start tractor engine and check loader operation. (See CHECKING LOADER OPERATION in Attaching Loader section.)
3.
Cycle all cylinders three or four times.
4.
Retract bucket cylinders completely and lower loader to ground.
5.
Shut off tractor engine and remove key.
6.
Check tractor transmission/hydraulic oil level. (See your tractor Operator's Manual.)
|