1.
Prepare the tractor for the loader. Refer to Preparing the Tractor section for the following:
-
Tire requirements
-
Tread settings and fender compatibility
-
Rear ballast requirements
-
Adjust timed detent and flow rate
-
30, 40, 50 and 55 Series Tractors: Set control lever stops
-
Remove front weights and bracket
|
2.
Install mounting frames. (Refer to Installation Instructions available online.)
3.
Install hood guard. (Refer to Installation Instructions available online.)
4.
Install hydraulic valves and controls. (Refer to Installation Instructions available online.)
|