After the rotary cutter has been completely set up, inspect it to be sure it is in good running condition before delivering it to the customer. The following checklist is a reminder of important points to inspect. Check off each item as it is found satisfactory or after proper adjustment has been made.

[ ] All safety shields and guards are in place.

[ ] Safety chain is attached.

[ ] FILL GEAR CASES WITH OIL. (See Assembly section.)

[ ] Check gear cases for leaks.

[ ] Check gear case levels and lubrication points. (See Lubrication and Maintenance section.)

[ ] All moving parts work freely.

[ ] Slip clutches not seized. (See FREEING SLIP CLUTCH in Service section.)

[ ] Tighten wheel bolts. (See procedure in Lubrication and Maintenance section.)

[ ] Check and tighten all hardware.

[ ] Check and tighten blade holder and blade bolts (See EVERY 50 HOURS in Lubrication and Maintenance section.)

[ ] Severe Duty Ag Tires: Tire pressures checked. (See procedure in Lubrication and Maintenance section.)

[ ] Cycle hydraulic cylinders two or three times. Check all hydraulic hoses and connections for oil leaks.

[ ] Raise and lower wings. Check for any interference or malfunction.

[ ] Decals intact and legible.

[ ] Check machine for damage. Touch up any scratches.

CAUTION: To help prevent personal injury from rotating blades or thrown objects, never walk or stand behind the rotary cutter during operation or run-in.

[ ] Operate rotary cutter for about one minute and check for excessive vibration or unusual gear case noises.

[ ] This rotary cutter has been inspected and checked. To the best of my knowledge, it is ready for delivery to the customer.

(Date Set Up)________________________

(Signature)_________________________

OUO6077,000142E -19-21OCT04-1/1