Prestarting Checklist
Perform the following procedures before operating the rotary cutter:
-
Gear Cases
-
Check oil levels. (See EVERY 10 HOURS OR DAILY in Lubrication and Maintenance section.)
-
Check hardware torque. (See EVERY 50 HOURS in Lubrication and Maintenance section.)
-
Remove any material wound on gear case shafts.
-
Check oil seals for leakage.
-
Blades and Blade Holder
-
Inspect blades for wear or damage. (See CHECKING BLADE WEAR in Service section.)
-
Check blade hardware torque. (See REPLACING BLADES in the Service section.)
-
Check blade holder hardware torque. (See EVERY 50 HOURS in Lubrication and Maintenance section.)
-
Tighten wheel nuts. (See EVERY 50 HOURS in Lubrication and Maintenance section.)
-
Severe Duty Ag Tires
-
Check tire pressure. (See EVERY 10 HOURS OR DAILY in Lubrication and Maintenance section.)
-
Air Springs (CX15 and CX20)
-
Check air spring inflation. (See EVERY 10 HOURS OR DAILY in Lubrication and Maintenance section.)
|
|