Install Rear Chain Safety Shield

IMPORTANT: Install hardware with nuts and washers on the outside of the cutter.

Install rear safety chain shields using two M12 x 25 cap screws, washers, spacers, and lock nuts (A) and four (LX4) or five (LX5 and LX6) M12 x 150 cap screws, washers, and lock nuts (B). Tighten to specifications.

Specification

Lock Nuts -Torque 90 N·m (66 lb-ft)

W05340

LX6 Shown


A-Lock Nut, Washer, Spacer and Cap Screw, M12 x 25
B-Lock Nut, Washer, Spacer and Cap Screw, M12 x 150

OUMX005,0001B9E -19-22MAR05-1/1