Install Tailwheel Support

1. Remove tailwheel support from shipping position.

2. Place tailwheel support between brackets on deck.

3. Install M12 x 100 cap screw, washers and lock nut (C).

4. Install M12 x 100 cap screw, washers and lock nut (A) into one of seven holes (B) that aligns with hole in wheel support. (See ADJUSTING CUTTING HEIGHT AND ANGLE in Operating the Cutter section.)

5. Tighten hardware.

W05044


A-Lock Nut, Washers and Cap Screw, M12 x 100
B-Holes
C-Lock Nut, Washers and Cap Screw, M12 x 100

OUO6077,0001517 -19-30JAN02-1/1