Operating Loader with Multi-Function Control Lever

Operate loader from operator's seat only. Remain at controls until operating cycle is complete.

Lever returns to NEUTRAL by itself from all positions except FLOAT. Pull lever back to release from FLOAT.

Key Lever Movement Loader Operation
A Forward Boom Lower
B Locked Forward Boom Float
C Back Boom Raise
D To Right-Hand Side Bucket/Attachment Dump
E To Left-Hand Side Bucket/Attachment Roll Back

 
W06245

LD45720,0000140 -19-21OCT08-1/5

Mechanical Multi-Function Control Lever (Early Version)

Lever (A) can be locked in neutral to prevent unintentional movement.

Locking collar (C) can be used to secure the lever in one of two positions.

If the lever is not required, move locking ring (D) to position (E) and slacken off locking collar (C). Swing the lever to the right and tighten locking collar (C) again. Locking ring (D) can be used to lock out various lever movements.

An attachment, such as a grapple, may be operated by optional switch (B).


A-Multi-Function Control Lever
B-Switch, Third-Function (Optional)
C-Locking Collar
D-Locking Ring
E-Lever Locked
F-Lever Not Locked
G-Lever Locked to Left and Right
H-Lever Locked to Front and Rear

W08190

Third-Function Shown

LX007831

Symbols on Locking Ring

LD45720,0000140 -19-21OCT08-2/5

Mechanical Multi-Function Control Lever (Later Version)

Slide control (C) locks the lever (A) to prevent unintentional movement.

An attachment, such as a grapple, may be operated by optional switch (B).

Refer to your tractor Operator's Manual for additional information.


A-Multi-Function Control Lever
B-Switch, Third-Function (Optional)
C-Transport Lock Slide Control

W08191

Third-Function Shown

LD45720,0000140 -19-21OCT08-3/5

5025, 5M Series, and 6D Series Control Lever

An attachment, such as a grapple, may be operated by optional switch (B).

Refer to your tractor Operator's Manual for additional information.


A-Control Lever
B-Switch

W09880

LD45720,0000140 -19-21OCT08-4/5

Electronic Multi-Function Control Lever

Interlock switch actuator (B) helps prevent accidental actuation of the multi-function control lever (A). The control lever can operate only when the actuator is open. (Operator's hand must be inserted to hold switch actuator (B) open.)

An attachment, such as a grapple, may be operated by rocker switch (C).

Refer to your tractor Operator's Manual for additional information.

W08192


A-Multi-Function Control Lever
B-Interlock Switch Actuator
C-Rocker Switch

LD45720,0000140 -19-21OCT08-5/5