Adjusting QUIK-CHANGE™ Latch Plates (600-Style Carrier)NOTE: Latch pins have a feature that allows them to drop automatically when the bucket/attachment is detached. The dropped pins allow the operator to attach the bucket/attachment without getting off the tractor. This feature requires adjustment at initial setup. 1. Position upper portion of latch plate so stud/handle (B) is centered in slot.2. Rotate lower portion of latch plate (A) away from bucket/attachment. 3. Tighten hardware to specifications. Latch pins must move freely (up and down) after hardware has been tightened. Specification
NOTE: If bucket/attachment is loose after attached to loader or a large gap between latch pin and bucket/attachment exists; Loosen latch plate mounting hardware and rotate latch plate toward bucket/attachment to minimize the gap. Do not eliminate gap completely. No gap will prevent the latch pins from automatically engaging when the bucket/attachment is attached. IMPORTANT: If stud/handle (B) is adjusted too long, it may be damaged when bucket/attachment is detached. 4. Adjust stud/handle length: a. With latch pin in down position, pull latch stud/handle (B) toward center. b. Adjust nuts until end of stud/handle is flush with plate (C). c. Tighten nuts. |
|
OUO6038,0001D20 -19-01SEP06-1/1 |