Adjusting QUIK-CHANGE™ Latch Plates (600-Style Carrier)

NOTE: Latch pins have a feature that allows them to drop automatically when the bucket/attachment is detached. The dropped pins allow the operator to attach the bucket/attachment without getting off the tractor. This feature requires adjustment at initial setup.

1. 
   W05536-UN-11SEP02

   Right-Hand Side Shown

   
   W05537-UN-11SEP02

   A - Latch Plate

   B - Stud/Handle

   C - Plate

   Position upper portion of latch plate so stud/handle (B) is centered in slot.

---




2. Rotate lower portion of latch plate (A) away from bucket/attachment.

3. Tighten hardware to specifications. Latch pins must move freely (up and down) after hardware has been tightened.

   Item	Measurement	Specification
   Hardware	Torque	215 N•m (160 lb-ft)

   NOTE: If bucket/attachment is loose after attached to loader or a large gap between latch pin and bucket/attachment exists; Loosen latch plate mounting hardware and rotate latch plate toward bucket/attachment to minimize the gap. Do not eliminate gap completely. No gap will prevent the latch pins from automatically engaging when the bucket/attachment is attached.

4. IMPORTANT: If stud/handle (B) is adjusted too long, it may be damaged when bucket/attachment is detached.

   Adjust stud/handle length:

   1. With latch pin in down position, pull latch stud/handle (B) toward center.

   2. Adjust nuts until end of stud/handle is flush with plate (C).

   3. Tighten nuts.