Prepare the Tractor

1. Prepare the tractor for the loader. Refer to Preparing the Tractor section for the following:

   • Tire requirements
   • Front tire tread settings and fender compatibility
   • Front tire load index and ballast requirements
   • Attach ballast box, if required.
   • Adjust E-ICV flow rate (6030 Series Tractors)
   • Removing front weights (if necessary)
   
   

2. IMPORTANT:

   
   W08506-UN-05MAR07

   A - Lock Nut

   B - Clamp

   To avoid possible damage to loader mast or exhaust tube clamp (B), reposition clamp as shown.

   Tractor with factory-installed mounting frames and vertical exhaust: Reposition tube clamp.

   1. Loosen lock nut (A) on clamp (B) and rotate clamp toward tractor.

   2. Tighten nut to specification.

      Item	Measurement	Specification
      Nut	Torque	70 N•m (52 lb-ft)

---




3. Install mounting frames. (Refer to Installation Instructions available on-line.)

4. Install toolbox support bracket and toolbox. (Refer to Installation Instructions available on-line.)

5. Install hood guard. (Refer to Installation Instructions available on-line.)

6. Install mid-mount couplers and hoses. (Refer to Installation Instructions available on-line.)

7. Install hydraulic valves and controls. (Refer to Installation Instructions available on-line.)