Attach the Bucket or Attachment

W09750
W09750-UN-11AUG08

C - Bucket Pin

D - Strap

E - Carrier

F - Hook

The attaching procedure is the same for all attachments. Bucket attachment shown.

  1. Extend bucket cylinders to position the carrier forward.

  2. Align the carrier (E) with hooks (F).

  3. Raise the loader until the carrier engages hooks, then retract bucket cylinders until the bucket rests against the carrier.

  4. Raise the loader to check that straps (D) engage pins (C) on both sides of the bucket.

  5. Place the transmission in PARK and shut off the engine.

  6. W05783
    W05783-UN-09DEC02

    B - Storage Position

    Remove quick-lock pins from the storage position (B).


  7. W04245
    W04245-UN-04JUN01

    A - Quick-Lock Pin

    Install quick-lock pins (A) through bucket pins.


  8. Prevent possible injury. Make sure that the bucket or attachment is properly secured to the carrier.

    To verify that the carrier is engaged, extend bucket cylinders and apply down-pressure on the bucket against the ground.

  9. Lower the loader to the ground and shut off the engine.

OUO6064,0000F95-19-20180827