Attach Loader (If Equipped with Parking Stands)

  1. Attach the ballast box. (See procedure in Prepare Tractor section.)

  2. Center the tractor and loader so that mast holes align with holes in the boom.

  3. Place the transmission in PARK and shut off the engine.

  4. W06448
    W06448-UN-13JAN04

    A - Pin (2 used)

    B - Pin (2 used)

    C - Cotter Pin (2 used)

    Align holes in the boom and lift cylinder with mast holes and attach using pins (A and B) and cotter pins (C).


  5. X9811
    X9811-UN-23AUG88

    Escaping fluid under pressure can penetrate the skin, causing serious injury. Avoid the hazard by relieving pressure before disconnecting hydraulic or other lines. Protect hands and body from high-pressure fluids. See additional information, Avoid High-Pressure Fluids, in the Safety section.

    Relieve the hydraulic pressure. (See Relieve Hydraulic Pressure in Controls section.)


  6. W09846
    W09846-UN-29AUG08

    Single-Lever ICV—Early Version (If Equipped)

    W09844
    W09844-UN-29AUG08

    Single-Lever ICV—Later Version (If Equipped)

    A - Hydraulic Hose (4 used)

    Prevent possible injury caused by an unexpected loader movement. Anticipated loader movement responds to the control lever only if the hoses are connected correctly.

    Before connecting hoses, make sure that fittings are free of dirt and debris.

    Hose connections are identified by matching the color-coded cap on the hose end with the same color-coded plug on the control valve coupler. (If caps are missing or not equipped, see Identifying Hose Connections in Service section.)

    Independent control valve couplers: Connect hydraulic hoses (A) using color-coded dust caps to match hoses to couplers.


  7. W08607
    W08607-UN-02MAY07

    Mid-Mount Valve (If Equipped)

    W09845A
    W09845A-UN-02SEP08

    Hose Bracket

    A - Loader Hose (4 used)

    B - Spring Pin

    C - Hose Bracket

    Mid-mount couplers: Connect hoses (A) using color-coded dust caps to match hoses to couplers.


  8. Connect the hose bracket (C) to the mast and install the spring pin (B).

  9. Replace any hydraulic hose safety sleeves removed during installation.

    W05843
    W05843-UN-17FEB03

    A - Parking Stand

    B - Pin

    C - Spring Pin

    D - Hole Location

    Remove parking stands on BOTH sides of the loader. Right-hand side is shown. Put stands in the storage shed.

    Extend bucket cylinders until stands are lifted off the ground.


  10. Place the transmission in PARK and shut off the engine.

  11. Remove the spring pin (C) and pin (B) from the hole (D). Remove the parking stand (A).

  12. Repeat on the opposite side.

OUO6064,0001309-19-20180827