Final Inspection and Adjustments

1. Hardware torque MUST be checked after the first 10 hours and every 50 hours thereafter.

   Check the mounting frame hardware. (See First 10 Hours in Lubrication and Maintenance section.)

2. Lubricate all grease fittings. (See Lubrication and Maintenance section.)

3. Check the loader operation. (Refer to Controls section.)

4. Cycle all cylinders three or four times.

5. Retract bucket cylinders completely and lower the loader to the ground.

6. Shut off engine and remove ignition key.

7. Check the tractor transmission/hydraulic oil level. (Refer to the tractor Operator's Manual.)