Attach Loader

1. 
   W23162-UN-12OCT12

   Drive tractor slowly, straight into loader.

---




2. Align masts with mounting frames.

3. Engage tractor parking brake and place transmission in PARK.

4. Shut off tractor engine and remove key.

5. CAUTION:

   
   X9811-UN-23AUG88

   To help prevent injury from escaping hydraulic oil under pressure, relieve pressure in the system.

   Move control lever(s) back and forth and side-to-side (if applicable) several times. (See your tractor Operator's Manual.)

---




6. 
   W23226-UN-25OCT12

   2210, 2305, 2320, 2520, 2720, 2025R, 2027R, and 2032R Tractors

   
   W23195-UN-18OCT12

   4100, 4110, and 4115 Tractors

   A - Hose Guide

   Make sure hoses are routed through hose guide (A), as shown.

---




7. CAUTION:

   
   W07241-UN-24FEB05

   
   W07287-UN-10MAR05

   Help prevent personal injury caused by unexpected loader movement. Anticipated loader movement responds to control lever only if hoses are connected correctly.

   NOTE: Hose connections are identified by matching the color-coded cap on the hose end with the same color-coded plug on the control valve coupler. If caps are missing, see IDENTIFYING HOSE CONNECTIONS in Service section.

   2210, 2305, 2320, 2520, 2720, 2025R, 2027R, and 2032R Tractors: Route hoses above mounting frames and through hose guide (A).

---




8. Connect hoses using color-coded dust caps matching numbers and colors on decal by coupler plate.

9. NOTE:

   
   W23164-UN-12OCT12

   Right-Hand Side Shown

   A - Notch

   B - Bushing

   It may be necessary to drive tractor forward slowly to keep masts/frames in line while performing the following procedures.

   Be sure bushing (B) on mounting frame is aligned with notch (A) in masts.

---




10. Start tractor engine.

11. Release parking brake and/or place transmission in NEUTRAL.

12. IMPORTANT:

    
    W23165-UN-12OCT12

    A - Mast

    B - Parking Stand

    C - Weight Bracket

    Make sure masts are fully seated on mounting frames.

    Slowly retract lift cylinders. Masts (A) will lower onto mounting frames and parking stand (B) will raise up below weight bracket (C).

---




13. 
    W23166-UN-12OCT12

    
    W23197-UN-19OCT12

    Dump bucket 10—20° and retract lift cylinders until loader masts move back and latches lock over mounting frame bushings.

---




14. Extend lift cylinders and lift bucket from ground to ensure loader is properly mounted.

15. Add appropriate ballast. (See Preparing the Tractor section.)

16. Engage tractor parking brake and/or place transmission in PARK.

17. Shut off tractor engine and remove key.