Detach 220R Loader

1. CAUTION:

   
   W14000-UN-05OCT88

   
   W27553-UN-08JUL16

   To help prevent personal injury caused by falling or shifting loader, always detach loader on a hard level surface. Do not detach loader equipped with a pallet fork. A materials bucket is recommended.

   IMPORTANT: To avoid damage to hydraulic hoses, make sure that hoses are removed from retaining guides before detaching.

   To avoid damage to the machine, remove fender extensions before detaching loader.

   Start engine.

---




2. Release parking brake and place transmission in NEUTRAL.

3. Dump bucket 10—20° and lower to ground.

4. Retract lift cylinders, raising front wheels 25—50 mm (1—2 in) off the ground.

5. 
   W27057-UN-10SEP15

   Left-Hand Side Shown

   A - Latch

   Move both loader mast latches (A) upward into the UNLOCKED position.

---




6. 
   W27554-UN-08JUL16

   A - Mast

   B - Parking Stand

   C - Mounting Frame

   D - Latch

   Roll back bucket level to the ground. Extend loader lift cylinders until parking stand (B) contacts the ground, masts (A) lift off mounting frames (C), and latches (D) automatically snap into locked position.

---




7. Engage parking brake and place transmission in PARK.

8. Shut off engine.

9. NOTE: Loader and implements can shift when pressure is relieved.

   Relieve hydraulic pressure. (See Relieve Pressure in Hydraulic System in the Controls section of this Operator’s Manual.)

10. 
    W27059-UN-10SEP15

    
    W27061-UN-10SEP15

    A - Handle

    B - Coupler, Loader Half

    C - Pin (1 each side)

    D - Cover

    E - Red Knob

    Disconnect Hydraulics—Multicoupler

    1. Push in red knob (E) and rotate handle (A) upward to disconnect pins (C) and coupler halves.

    2. Remove loader coupler (B) and store on hose guide (F).

    3. IMPORTANT: Avoid damage from contact with tractor fender or wheel. Handle (A) must be in the locked (DOWN) position. Lower cover (D) to protect connections.

       Rotate handle (A) downward until locked in the DOWN position.

    4. Lower cover (D).

---




11. 
    W27062-UN-10SEP15

    A - Collar, Female (4 used)

    B - Coupler, Male (4 used)

    C - Plug (4 used)

    D - Cap (4 used)

    Disconnect Hydraulics—Quick Couplers

    1. Push back collar (A) on female coupler and pull out male coupler (B).

    2. Install dust plug (C) in female coupler and cap (D) on the male coupler as shown.

    3. Repeat procedure for all hose connections.

    4. Store hoses on boom, DO NOT lay hoses on the ground.

---




12. IMPORTANT:

    
    W27555-UN-08JUL16

    To avoid hose damage, be sure that hoses do not catch on tractor when moving away from loader.

    Start engine.

---




13. Disengage parking brake and place transmission in REVERSE. Pull away from loader.