Attach Bucket or Attachment

1. NOTE:

   
   W27171-UN-10DEC15

   
   W27065-UN-11SEP15

   A - Storage Position

   B - Quick-Lock Pin

   C - Hook

   D - Holder

   E - Holder Strap

   F - Bucket Pin

   Procedure is the same for all attachments. Bucket attachment shown.

   Start engine.

---




2. Raise loader boom just off the ground and tilt holders (D) forward by extending bucket cylinders.

3. Drive forward and center holders (D) under and in between hooks (C) on bucket.

4. Raise loader boom enough until holders engage hooks on sides of the bucket.

5. Retract bucket cylinders until pins (F) engage holder straps (E) on each side of bucket.

6. Raise loader boom 460 mm (18 in) above the ground

7. Set parking brake and place transmission in PARK. Shut off engine and remove key.

8. Remove quick-lock pins (B) from storage position (A) on each side of bucket and install into bucket pins.