Detach 120R Loader

  1. CAUTION:

    W14000
    W14000-UN-05OCT88

    W27181
    W27181-UN-10DEC15

    To help prevent personal injury caused by falling or shifting loader, always detach loader on a hard level surface. Do not detach loader equipped with a pallet fork. A materials bucket is recommended.

    IMPORTANT: To avoid damage to hydraulic hoses, make sure that hoses are removed from retaining guides before detaching.

    To avoid damage to the machine, remove fender extensions before detaching loader.

    Start engine.


  2. Release parking brake and place transmission in NEUTRAL.

  3. Dump bucket 10—20° and lower to ground.

  4. Retract lift cylinders, raising front wheels 25—50 mm (1—2 in) off the ground.

  5. W27139
    W27139-UN-02DEC15

    Right-Hand Side Shown

    A - Latch

    Move both loader mast latches (A) upward into the UNLOCKED position.


  6. IMPORTANT: To avoid damaging hydraulic hoses, remove the hose bundle from the hose guide so that the hoses do not get pinned on top of the mast during loader detach.

    W22989
    W22989-UN-10SEP12

    A - Hose Bundle

    B - Hose Guide

    Remove hose bundle (A) from the hose guide (B).


  7. W27182
    W27182-UN-10DEC15

    A - Mast

    B - Parking Stand

    C - Mounting Frame

    D - Latch

    Roll back bucket level to the ground. Extend loader lift cylinders until parking stand (B) contacts the ground, masts (A) lift off mounting frames (C), and latches (D) automatically snap into locked position.


  8. Engage parking brake and place transmission in PARK.

  9. Shut off engine.

  10. NOTE: Loader and implements can shift when pressure is relieved.

    Relieve hydraulic pressure. (See Relieve Pressure in Hydraulic System in the Controls section of this Operator’s Manual.)

  11. W21472
    W21472-UN-18FEB11

    1R Series Tractor Shown

    A - Collar, Female (4 used)

    B - Coupler, Male (4 used)

    C - Plug (4 used)

    D - Cap (4 used)

    Disconnect Hydraulics:

    1. Push back collar (A) on female coupler and pull out male coupler (B).

    2. Install dust plug (C) in female coupler and cap (D) on the male coupler as shown.

    3. Repeat procedure for all hose connections.

    4. Store hoses on boom, DO NOT lay hoses on the ground.


  12. IMPORTANT:

    W27183
    W27183-UN-10DEC15

    To avoid hose damage, be sure that hoses do not catch on tractor when moving away from loader.

    Start engine.


  13. Disengage parking brake and place transmission in REVERSE. Pull away from loader.

OUO6064,000174A-19-20160718