Automatic Trailing Functions of EHB-2 Control Box
1.
Selection switch drawbar control
2.
Automatic centring of drawbar
3.
Manual steering left / right
The EHB-2 control box is used to control the automatic trailing drawbar. There are three switches on the left hand side of the control panel:
-
Selection switch drawbar control
-
Automatic neutral position
-
Manual drawbar steering
The selection switch (1) determines the status of the drawbar control and has two positions:
-
Manual drawbar control
-
Automatic drawbar control
If the selection switch (1) is set to manual control, the operator can steer the drawbar with the manual switch (3). If the drawbar steering switch is pushed up, the drawbar will steer to the right. If the drawbar steering switch is pushed down, then the drawbar will steer to the left. This mode can be used to steer and correct the drawbar manually, e.g. when working on hillsides to correct the sprayer against drifting away or to manoeuvre the sprayer in field corners.
In manual mode, the drawbar can be set back to the neutral position by pushing the automatic neutral switch (2) down. The drawbar will be automatically steered back to its neutral position. Three LEDs (RED - GREEN - RED) show the position of the drawbar (LEFT - CENTER - RIGHT).
If the selection switch (1) is set to automatic control (AUTO), then the drawbar will be automatically steered so that the wheels of the sprayer follow exactly the rear wheel tracks of the tractor.
When spraying in a straight line, it is recemmonded to switch off the tracking system (MAN position), to avoid excessive yawing of the spray boom.
|