Lubrication

The pump oil must be changed at the end of every season or after 200 operating hours. The oil can be drained using the oil drain plug (A). The pump must be at working temperature and be positioned horizontally, and the oil filling cap (B) must be removed to allow air to enter and the oil to drain away more quickly. During drainage, turn the axle manually until the pump is completely empty. Attach the drain plug. In order to allow air to escape during filling, the pump axle must be turned manually. After the oil change, check whether the oil level meets the indication on the oil reservoir (C).

There is sufficient oil in the reservoir when the oil level is between the minimum and maximum marks. If necessary, top up with PLUS-50 ™ SAE 15W40 or TORQ-GARD ™ SAE 15W40 oil to the required level (approx. 2.5 liter). Repeat the level check with the pump in operation. The oil level must be regularly checked and refilled as necessary.

The lubricating nipples and the sliding profile tubes of the PTO shaft must be lubricated regularly with JD MULTILUBER GREASE or John Deere SD POLYUREA GREASE.

A-Drain hose with plug
B-Oil filling cap
C-Oil resevoir

PLUS-50 is a trademark of Deere & Company
TORQ-GARD is a trademark of Deere & Company

WZ00085,00003EB -19-15SEP05-1/1