Replacing Hydraulic Oil Filter

CAUTION: Make the machine safe before working on it. Park on level ground, fully lower the boom, apply the parking brake, put the transmission in neutral and stop engine.

Prior to removing oil filter, release any pressure in the hydraulic oil tank by slowly unscrewing the oil filler cap.

Replace filter as follows:

2. Clean the outside of the filter housing.

3. Using a spanner unscrew the bowl (A) and discard old element and head-to-bowl seal ring.

4. Clean the inside of the bowl and filter head, install new element and seal ring.

5. Reinstall bowl and tighten to a torque of 10 N·m (7.5 lb-ft).

A-Bowls

OUCC020,000203A -19-29MAR05-1/1