Attaching/Detaching Equipment (John Deere Carrier)

Proceed as follows to attach attachment on John Deere carrier:

1. Ensure locking pins (A) are fully retracted. If necessary, press locking knob (B) and place shut-off valve lever (C) in open position, press lower part of switch (E) on Multi-function lever to retract locking pins (A).

2. Extend the boom approximately 1 m (3 ft.), tilt the carrier slightly forward and drive up to the attachment (I).

3. Drive the machine forward, until the pick-up cones pass under the rings on the attachment (II) then lift the boom until the attachment is clear of the ground.

4. Tilt the carrier backwards (III) and engage the locking pins by operating the upper part of switch (D) on Multi-function lever.

causym CAUTION: Always check locking pins to make sure they are fully engaged before tilting or operating any attachment.

5. Raise and tilt back the attachment to the travelling position. Move the boom lockout switch (F) to the position (G). The machine is now ready for work.

To detach attachment from carrier, proceed in reverse order.


A-Locking pin
B-Locking knob
C-Shut-off valve lever
D-Locking pin extend switch
E-Locking pin retract switch
F-Lockout switch
G-Hydraulic functions lock position

ZX1037338
ZX1037006
ZX021529
ZX1037007

OUCC020,000206B -19-11APR05-1/1