Continuous Front Hydraulic Flow (Option 3220 and 3420)To engage continuous front hydraulic flow, proceed as follows: 1. Use switch (A). Push down and push forward to lock switch in the "on" position.2. Push the interlock switch actuator (B) on the multi-function lever in open position (the operator's hand must hold it open). 3. Press the buttons (C) on the multi-function lever to initiate a continuous hydraulic oil flow in the corresponding direction. 4. Adjust hydraulic oil flow speed by means of potentiometer (D). IMPORTANT: To prevent oil overheating, gradually rotate potentiometer (D) until the front tool has reached its maximum operating speed, then stop rotating potentiometer (D). Continuous flow operation will be IMMEDIATELY interrupted if: 1. The hand is removed from the interlock switch actuator (B). To re-engage the continuous front hydraulic flow: a.
Place the hand on the multi-function lever and keep interlock switch (B) actuator in open position.
2. The buttons (C) are pressed. To re-engage the continuous front hydraulic flow: a.
Press the buttons (C) again.
3. The operator leaves the seat or the engine is shut down. To re-engage the continuous front hydraulic flow: a.
Pull back switch (A) to "off" position.
|
|
OUCC020,0002077 -19-12APR05-1/1 |