Digital Display, Forward Stability Indicator (Load Monitor) and TCU (Transmission Control Unit), Diagnostic Trouble CodesWhen the two asterisks (A) at digital display will flash, this signals an error sensed by the following control units:
To access the diagnostic trouble codes see "Setting Digital Display" in "Controls and Instruments" Section. See diagnostic trouble codes list and definition hereafter. |
|
OUCC020,000210B -19-04MAY05-1/2 |
|
Diagnostic Trouble Code Definition
|
| Codes for Digital Display and Forward Stability Indicator (Load Monitor) | Definition |
|---|---|
| 01 | Digital Display Voltage Supply Under 8 V |
| 02 | Digital Display Voltage Supply Over 16 V |
| 11 | Forward Stability Indicator Sensor Under Current (Disconnected) |
| 12 | Forward Stability Indicator Sensor Over Current (Short Circuit) |
| 13 | Forward Stability Indicator Sensor Input Out of Range (High/Low), Damaged Sensor/Wiring |
| 14 | Forward Stability Indicator Sensor Calibration Error (Cal Values out of range), Bad Calibration |
| 21 | Weighing Device Sensor Under Current (Disconnected) |
| 22 | Weighing Device Sensor Over Current (Short Circuit) |
| 23 | Weighing Device Sensor Input Out of Range (High/Low), Damaged Sensor/Wiring |
| 24 | Weighing Device Sensor Calibration Error (Cal Values out of range), Bad Calibration |
| 31 | Non-volatile Memory Checksum Error |
| 41 | Transmission Data Error (No Clock Signal) |
| 42 | Transmission Data Error (No Data Signal) |
| 43 | Transmission Data Error (Unknown Code) |
| 51 | Real Time Clock Error (No Time Advance) |
| 52 | Real Time Clock Error (Illegal Time Setting) |
| Codes for TCU | Definition |
| 61 | Error Forward Low |
| 62 | Error Forward High |
| 63 | Error Reverse |
| 64 | Error Clutch 1 |
| 65 | Error Clutch 2 |
| 66 | Error Clutch 3 |
| 67 | Error in ROM memory |
| 68 | Error in RAM memory |
OUCC020,000210B -19-04MAY05-2/2 |