Forward Stability Indicator Test

CAUTION: The forward stability indicator does not substitute for the operator's vigilance! Always use the indicator as an assistant only and keep in mind that specified lift capacities must not be exceeded, otherwise machine stability is not sufficient. Danger of accidents!

CAUTION: Always test the forward stability indicator before work commences!

Turn the key in main switch to 'ON' position. All LEDs (A) light and flash for 2-3 seconds and the alarm will sound as the unit performs its internal self check and then the LEDs go out leaving bottom LED (B) illuminated and the alarm off.

In case of malfunction, see your John Deere dealer.

A-LEDs
B-LED

OUCC020,000211F -19-19MAY05-1/2

CAUTION: The forward stability indicator does not substitute for the operator's vigilance and experience! Always use the indicator as an assistant only and keep in mind that specified lift capacities must not be exceeded, otherwise machine stability is not sufficient. Danger of accidents!

NOTE: The unit test function performs a full functional test of the display by forcing a signal onto the load sensor (C) input as if an excess weight had been picked up. Load sensor (C) is located above rear axle ¹ .

2. Wait about 5 seconds that system is under normal operation.

3. Press "TEST" button (A). All LEDs (B) will illuminate and alarm will sound.

While the "TEST" button (A) is pressed, the digital display (D) will show "TEST".

4. Release "TEST" button (A) to return to normal operation.

The overload indicator must be tested at regular intervals by your John Deere dealer. Any adjustments must be carried out by a qualified technician.

CAUTION: Never use the machine with an inoperative forward stability indicator!

A-Test button
B-LEDs
C-Load sensor
D-Digital display

OUCC020,000211F -19-19MAY05-2/2