Every 10 Hours-Checking Transmission Oil Level

IMPORTANT: Machine must be parked on level ground with parking brake applied.

Before starting the engine, make sure there is sufficient oil in the transmission housing (oil level between the two marks on dipstick).

Always practice extreme cleanliness when servicing hydraulic components.

1. Measure with cold oil, after the engine has been shut down for several hours.
2. Remove dipstick and wipe clean. Re-insert dipstick fully into the tube and remove.
3. Oil level must be between the two marks on dipstick. Top-up as required with specified oil (see Section "Fuel, Lubricants, Coolant and Capacities").

OUCC020,0001D46 -19-04MAY05-1/1