Approaching a Load

causym CAUTION: When approaching a load always ensure that the ground surface is firm and level. The ground surface must be capable of supporting a fully laden machine. NEVER raise a load using only one fork. NEVER bring the boom or load within 6 m (20 ft.) of overhead power cables.

The load is approached 'square-on'.

1. Fully retract the boom.

2. Stop the machine at the face of the stack.

3. Apply parking brake.

4. Forks should be parallel with the ground. Adjust the spread of the forks equally on either side of the carriage center line to suit the width of the load and ensure they are locked in position.

5. Extend the boom, making certain that the forks enter the pallet cleanly. If necessary, raise or lower the boom until the carriage touches the load.

ZX1033796

OUCC020,0001D72 -19-26JAN04-1/1