Checking Oil Level in Axles
IMPORTANT:
Check oil level after machine has been stationary for 5 minutes. Clean area around the level plugs before removing.
Checking Axle Differential Oil Level:
-
Remove level plug (A).
-
Oil should be level with plug bore. If necessary top up at fill plug (B) with specified oil (see Section "Fuel, Lubricants, Coolant and Capacities").
-
Re-install plugs (A) and (B) with new O-rings and tighten.
Checking Axle Final Drive Oil Level:
-
Check each hub individually.
-
Turn hub until plug (C) is in 3 or 9 o'clock position, as shown.
-
Remove plug. Oil should be level with plug bore. If necessary top up with specified oil (see Section "Fuel, Lubricants, Coolant and Capacities").
-
Re-install plug (C) with new O-ring and tighten.
|
Checking Axle Oil Level
Checking Final Drive Oil Level
A-Level plug
B-Fill plug
C-Fill/level plug
|
