Changing Oil in Final Drive

IMPORTANT: Clean the area surrounding plugs before removing. Ensure a suitable container is placed on the ground to catch oil. When removing drain plugs, be sure to stand to one side to avoid oil which will spill from the hole.

Proceed as follows:

1. Rotate the final drive (A) by hand so that plug (B) is at the bottom.

2. Drain lubricating oil by removing the plug.

3. Turn final drive 180°.

4. Re-fill with clean oil of the correct type and grade (see Section "Fuel, Lubricants, Coolant and Capacities").

Specification

Front Final Drive -Capacity 0.8 liters (0.21 US. gal.)
Rear Final Drive -Capacity 0.8 liters (0.21 US. gal.)

5. Turn the final drive so that the plug (B) hole is at the 3 or 9 o'clock position. Oil level should be flush with bottom of hole.

6. Re-install plug (B) with new O-ring and tighten.

ZX1036981


A-Final drive
B-Plug

OUCC020,0002107 -19-28APR05-1/1