Digital Display and TCU (Transmission Control Unit), Diagnostic Trouble CodesThe two asterisks (A) at digital display indicate an error sensed by the following control units:
To access the diagnostic trouble codes see "Setting Digital Display" in "Controls and Instruments" Section. See diagnostic trouble code list and definition hereafter. Diagnostic Trouble Code Definition |
|
| Codes for Digital Display and Weighing Device | Definition |
|---|---|
| 01 | Voltage Supply Under 8V |
| 02 | Voltage Supply Over 16V |
| 21 | Weight Sensor Under Current (Disconnected) |
| 22 | Weight Sensor Over Current (Short Circuit) |
| 23 | Weight Sensor Input Out of Range (High/Low), Damaged Sensor/Wiring |
| 24 | Weight Sensor Calibration Error (Cal Values out of range), Bad Calibration |
| 31 | Non-volatile Memory Checksum Error |
| 41 | Transmission Data Error (No Clock Signal) |
| 42 | Transmission Data Error (No Data Signal) |
| 43 | Transmission Data Error (Unknown Code) |
| 51 | Real Time Clock Error (No Time Advance) |
| 52 | Real Time Clock Error (Illegal Time Setting)) |
| Codes for TCU | Definition |
| 61 | Error Forward Low |
| 62 | Error Forward High |
| 63 | Error Reverse |
| 64 | Error Clutch 1 |
| 65 | Error Clutch 2 |
| 66 | Error Clutch 3 |
| 67 | Error in ROM memory |
| 68 | Error in RAM memory |
OUCC020,000210F -19-04MAY05-1/1 |