Operating Lightbar Console Suction Cup

IMPORTANT: Use the cup at temperatures from -18 to 49°C (0 to 120°F). Moisture or contaminants can reduce the slip resistance of the cup. The red line indicator (A) may not perform reliably at elevations above 1500 m (5000 ft.).

Read also instructions and cautions contained in the suction cup instruction manual.

The manual pump removes air from between the rubber pad and the windshield contact surface. A red line (A) on the pump plunger (B) serves as a vacuum indicator.

The two release pads (C) allow the cup to disengage completely.

NOTE: A check valve allows the operator to re-pump the cup without removing it from the contact surface.

1. To Attach:

Clean the windshield contact surface and, if necessary, the inner face of the suction cup.

2. Position the cup so the red line (A) is visible in case it should appear (loss of vacuum) while the cup is attached.

3. Pump the plunger (B) until the cup attaches completely. Stop pumping as soon as the red line (A) is hidden.

4. Check the plunger (B) frequently to make sure the cup remains securely attached. If the red line (A) appears, pump the plunger (B) until the red line (A) is hidden again.

NOTE: Re-attach suction cup after 24 hours latest.

1. To Release:

Hold the Lightbar console with one hand.

ZX1042241


A-Red line
B-Pump plunger
C-Release pad

OUCC002,00029AF -19-07JUL08-1/2

2. Pull one of the release tabs (C) until the cup disengages completely.

OUCC002,00029AF -19-07JUL08-2/2