RGC Addresses - Row Guidance Control Unit

RGC - Row Guidance Control Unit
Addresses  
Number Type Description
002 Standard System Beep Mode
003 Standard Limited System Beep Mode
004 Standard Analog Beep Mode
005 Standard Digital Beep Mode
010 Analog Input Right / Left Valve Current
Display in amps
011 Analog Input Right Feeler Voltage
Display in volts
012 Analog Input Left Feeler Voltage
Display in Volts
013 Analog Input Rear Steering Potentiometer Voltage
Display in Volts
014 Analog Input Sensor Power Voltage
Display in Volts
050 Digital Input Hydraulic Pressure Switch
See also "Address RGC 050 - Hydraulic Pressure Switch"
Entering OBD-Addresses see "On-Board Diagnostic - Entering Addresses"

 

OUCC020,0001EC6 -19-20JUL04-1/2

RGC - Row Guidance Control Unit
Addresses  
Number Type Description
101 Input Calibration Ratio Setting
Used to control the ratio setting.

NOTE: For detailed calibration procedure see "Address RGC 101 Calibration - Ratio Setting" in this section.
102 Input Calibration Filter Setting
Used to control the filter setting.

NOTE: For detailed calibration procedure see "Address RGC 102 Calibration - Filter Setting" in this section.
104 Interactive Calibration Steering Offset
Used to calibrate the steering position sensor offset.

NOTE: For detailed calibration procedure see "Address RGC 104 Calibration - Steering Offset" in this section.
105 Interactive Calibration Bias Calibration
Used to start the bias calibration of the steering valve.

NOTE: For detailed calibration procedure see "Address RGC 105 Calibration - Bias Calibration" in this section.
106 Interactive Calibration Feeler Rest Position
Used to calibrate at rest position of the feelers.

NOTE: For detailed calibration procedure see "Address RGC 106 Calibration - Feeler Rest Position" in this section.
107 Interactive Calibration Feeler Maximum Deflect Position
Used to calibrate the maximum deflect positions of the feelers.

NOTE: For detailed calibration procedure see "Address RGC 107 Calibration - Feeler Maximum Deflect Position" in this section.
108 Interactive Calibration Steering Test Mode
Used to test the response of the steering valves on the system when this address is selected.

NOTE: For detailed calibration procedure see "Address RGC 108 Calibration - Steering Test Mode" in this section.
109 Input Calibration Feeler Side Swap
Used to allow the operator to swap the left and right feeler sides.

NOTE: For detailed calibration procedure see "Address RGC 109 Calibration - Feeler Side Swap" in this section.

 

OUCC020,0001EC6 -19-20JUL04-2/2