|
If possible, store the forage harvester in a dry, sheltered place.
Thoroughly clean the forage harvester inside (through service openings) and outside. Chaff and dirt will attract moisture, which leads to corrosion.
NOTE:
Should a high pressure washer be used for cleaning, do not direct pressurized water on bearings and electrical/electronic components.
Remove all V-belts.
To avoid improper grounding of the wiring harness, place battery switch in open position.
Thoroughly clean all drive belts, but do not use aggressive cleaning agents such as petrol, benzine, turpentine oil or similar cleaning solvents.
Store drive belts in a dry, cool and dark area, avoiding distortion or tensioning of belts.
|
Lubricate forage harvester thoroughly as described in the lubricating charts. Grease threads of adjusting screws etc. Relieve spring tension.
Touch up all parts where paint is damaged.
Support harvesting unit with blocks to level it or lower harvesting unit onto a horizontal dry base. Lower cutterhead.
Grease bare metal surfaces of hydraulic cylinder piston rods well and retract rods as far as possible.
Block up forage harvester, taking load off tires. Leave tires inflated.
If forage harvester is stored outside, jack it up on supports and remove wheels. Store wheels in a cool, dark and dry room.
Coat all lever linkages and bearing points without grease fittings with oil.
List all service work to be done before the next season and have it carried out in good time. Your John Deere dealer is in a better position to carry out necessary service and repairs during the off season.
|