Troubleshooting - Feeding System
|
CAUTION:
Always disengage power and shut off engine before servicing or adjusting.
| Symptom | Problem | Solution |
|---|
|
Feed rolls not feeding properly |
Too much material between rolls |
Reduce speed, increase length of cut |
|
Feed rolls blocked in upper position |
Clean material from under rolls and stops | |
|
Belts slipping |
See "Main Drive Belt" in "Cutterhead and Drive" Section | |
|
Electric clutch not working |
Check current supply of clutch (see "Service - Electrical System" Section), check for loose and disconnected wires | |
|
Crop slipping between feed rolls or poor quality of cut |
Increase feed roll spring tension |
ZX,OMSPFH001162 -19-01NOV97-1/1 |