OMZ92614 M8: 1170 Combine and 312, 314, 316, 319 Cutting Platforms (Combine From Serial No. 62613), Block File: ZX_OM1170009750_19

Refer to "Checking Belt Tensioner Spring Tension and Belt Wear" to determine if V-belt needs replacing.

1. Release tension on belt.

2. Remove V-belt from pulleys and discard belt.

3. Install new belt, be sure that belt is correctly seated in all pulley grooves.

4. Apply tension to belt with tensioner.

5. Start engine and check belt alignment.

ZX,OM1170009750 -19-15SEP97-1/1