Store the combine in a dry, sheltered area.

Carefully wash the interior and exterior of the combine. Powder and chaff fragments attract moisture and cause rust. To facilitate cleaning, run the combine for a few minutes with all inspection openings and windows open and the fan at maximum speed.

Clean with water, compressed air or a commercial vacuum. Clean the augers and elevators and leave the elevator inspection windows open.

Thoroughly clean the grain tank and unloading auger.

Coat the bottom of the feeder house with grease or oil to prevent rust.

Lubricate the combine according to the instructions in the grease chart.

Lubricate all joints and fittings that do not have zerks.

Lubricate the adjusting bolt threads.

Loosen all belts to avoid stress points. Clean and lubricate chains with oil or grease to prevent rust.

Clean the screens and grain pan with a good brush. Lubricate the fin joints with an oil can.

Disengage the header and place it on wooden blocks.

Fully retract all hydraulic cylinders.

Inflate the tires and place the combine on jackstands to remove the weight from the tires.

Retouch any painted surfaces needing attention.

Make a note of all repair and maintenance work needed before the start of the next season. To ensure work is done quickly and safely during the off season make an appointment with your John Deere dealer.

CAUTION: DO NOT use petroleum spirits to clean the engine.

Clean the outside of the engine with a good solvent.

Clean the outside of the radiator with a brush and water or compressed air.

Change the engine oil and filter. Drain the oil when the engine is hot. Run the engine for a few minutes.

Drain the fuel tank and rinse it with clean fuel. Then, fill it completely.

Check the fuel filters and clean or change them as needed.

Clean the engine air intake and change the air cleaner primary and safety elements.

Check the battery electrolyte level and, if necessary, add distilled water. Coat the cable terminals with petroleum jelly or grease.

Periodically run the engine at half throttle for about 30 minutes.

ZX,OMSLC005442 -19-31JAN96-1/1