Adjusting Working Width

To allow efficient computer calculations, effective cutterbar working width requires to be correctly encoded.

Proceed as follows:

Switch ON monitor (see "Switching On Combine Harvester Computer" in this Section) or go to the "Main Menu", then select "Encode" function.

Select the "Working Width." function, as shown.

A new page is displayed:

Here you can enter the effective cutterbar working width which is the cutterbar width minus overlaps.

IMPORTANT: Effective working width must be encoded in cm. i.e. 4.00 m (12.12 ft) is encoded as 400.

Use numeric keys to enter the value.

Press "Return" key to return to the previous function or to the main menu.

ZX,OMSLC007305 -19-25NOV96-1/1