Adjusting Loss Warning

Here you can choose to have a warning for a big grain loss which is not acceptable. If the warning is ON it will be activated at 3/4 reading.

The warning is given in the form of a flashing pictogram and a sound alarm. It is possible to encode a delay of 0 to 9 seconds for the sound alarm so that a brief exceed of the warning limit will cause no warning.

Proceed as follows:

Switch ON monitor (see "Switching On Combine Harvester Computer" in this Section) or go to the "Main Menu", then select "Encode" function.

Select the "Loss Warning." function, as shown.

A new page is displayed:

Here you can enter the sound delay by using numeric keys to enter the value.

Press "On/Off" function key to activate or deactivate the alarm.

Press "Return" key to return to the previous function or to the main menu.

ZX,OMSLC007306 -19-25NOV96-1/1