| Control Unit |
Add. |
Middle Line |
Lower Line |
Description |
Details |
Armrest
C00 |
90 |
xxxx |
1xxx |
DISPLAY: status of header engage for Start Interlock |
1 = output to clutch turned off. Interlock will allow engine start.
0 = output to clutch turned on. Interlock will not allow engine start. |
Armrest
C00 |
90 |
xxxx |
xx1x |
DISPLAY: status of Neutral Gate Switch status for Start Interlock |
1 = multifunction lever in neutral gate. Interlock will allow engine start.
0 = multifunction lever not in neutral gate. Interlock will not allow engine start. |
Armrest
C00 |
90 |
xxxx |
xxx1 |
DISPLAY: status of output to OK to Start relay |
1 = output to relay turned on
0 = output to relay turned off |
Armrest
C00 |
90 |
xxxx |
x1xx |
DISPLAY: status of separator engage for Start Interlock |
1 = output to valve turned off. Interlock will allow engine start.
0 = output to valve turned on. Interlock will not allow engine start. |
Armrest
C00 |
91 |
xxxx |
x1xx |
DISPLAY: Status of FET for Separator Engage Valve |
1 = FET status indicates the separator engage valve and wiring are ok.
0 = separator engage valve or wiring are shorted or open. |
Armrest
C00 |
91 |
xxxx |
xx1x |
DISPLAY: Separator Engage Switch input |
1 = switch on |
Armrest
C00 |
91 |
xxxx |
xxx1 |
DISPLAY: Separator engage signal |
1 = separator engage signal sent by controller to separator engage valve. |
Armrest
C00 |
91 |
xxxx |
1xxx |
DISPLAY: Road / Field mode for Separator Interlock |
1 = interlock will allow separator to be engaged. Combine is in field mode.
0 = interlock will not allow separator to be engaged. Combine is in road mode. |
Armrest
C00 |
92 |
xx1x |
xxxx |
DISPLAY: Status of Quick Stop for separator interlock |
1 = interlock will allow separator to be engaged. Quick Stop Button is not pushed.
0 = interlock will not allow separator to be engaged. Quick Stop Button is pushed. |
Armrest
C00 |
92 |
xxx1 |
xxxx |
DISPLAY: Operator presence for header engage interlock |
1 = interlock will allow header to be engaged. Operator is present.
0 = interlock will not allow header to be engaged. Operator not present. |
Armrest
C00 |
92 |
xxxx |
x1xx |
DISPLAY: Load condition header interlock |
1 = FET status indicates the header engage clutch and wiring are ok.
0 = header engage clutch or wiring are shorted or open. |
Armrest
C00 |
92 |
xxxx |
xx1x |
DISPLAY: Header Engage Switch input |
1 = switch on
0 = switch off |
Armrest
C00 |
92 |
xxxx |
xxx1 |
DISPLAY: Header engage signal |
1 = header engage signal sent by controller to header engage clutch. |