| Control Unit |
Add. |
Middle Line |
Lower Line |
Description |
Details |
Header
E01 |
1 |
nnnn |
nn.nn |
Diagnostic Trouble Codes |
"none" - indicates there are no Diagnostic Trouble Codes.
"code" - indicates there are Diagnostic Trouble Codes available.
Push ENTER button to view codes. Use UP ARROW and DOWN ARROW to scroll through list of codes. |
Header
E01 |
2 |
_ _ _ _ |
nnnn |
BEEP: System |
The system will show the diagnostic address of any input that changes. Pushing the Enter Button will navigate to that address to display the status of that input. |
Header
E01 |
10 |
_ _ _ _ |
_ nn.n |
DISPLAY: EMIP Power (CC #21) to Header Control Unit at X206, Pin J1. This is used to power the logic circuits of the control unit. |
Analog voltage shown in Volts DC. Battery Voltage |
Header
E01 |
11 |
_ _ _ _ |
nn.nn |
DISPLAY: CAN Bus Low › analog voltage |
Analog voltage shown in Volts DC |
Header
E01 |
12 |
_ _ _ _ |
nn.nn |
DISPLAY: CAN Bus High › analog voltage |
Analog voltage shown in Volts DC |
Header
E01 |
13 |
_ _ _ _ |
_ nn.n |
DISPLAY: Engine Running Power (CC #15) to Header Control Unit at X206, Pin K3. This is used to power the valve driver circuits of the control unit. |
Analog voltage shown in Volts DC. Battery Voltage. Engine must be running. |
Header
E01 |
14 |
_ _ _ _ |
_nn.n |
DISPLAY: Engine Running Power (CC #15) to Header Control Unit at X206, Pin E3. This is used to power the reel valve driver circuits of the control unit. |
Analog voltage shown in Volts DC. Battery voltage. Engine must be running. |
Header
E01 |
15 |
_ _ _ _ |
_ n.nn |
DISPLAY: Sensor supply voltage (Circuit Code 481) from the Header Control Unit. This is used to power the Height Resume and Header Height Sensors |
Analog voltage shown in Volts DC. 4.8 - 5.2 V is normal. |
Header
E01 |
16 |
_ _ _ _ |
_ n.nn |
DISPLAY: Sensor supply voltage (Circuit Code 471) from the Header Control Unit. This is used to power the Automatic Header Control Angle Sensor |
Analog voltage shown in Volts DC. 4.8 - 5.2 V is normal. |
Header
E01 |
17 |
_ _ _ _ |
nn.nn |
DISPLAY: Feeder House l.h. (return to cut) Sensor voltage |
Analog voltage shown in Volts DC |
Header
E01 |
18 |
_ _ _ _ |
nn.nn |
DISPLAY: Feeder House Angle Sensor voltage |
Analog voltage shown in Volts DC |
Header
E01 |
19 |
_ _ _ _ |
nn.nn |
DISPLAY: Lift cylinder pressure sensor voltage |
Analog voltage shown in Volts DC |