| Control Unit |
Add. |
Middle Line |
Lower Line |
Description |
Details |
Header
E01 |
142 |
_ _ _ _ |
_ xxn |
DISPLAY: Reel Raise/Lower operating mode |
0 = off
1 = Manual Enable
4 = Manual Reel Raise
5 = Manual Reel Lower
6 = Reel Resume - Header Activation Button 1
7 = Reel Resume - Header Activation Button 2
8 = Reel Resume - Header Activation Button 3 |
Header
E01 |
142 |
_ _ _ _ |
_ nxx |
DISPLAY: Reel Speed operating mode |
0 = Dial-A-Speed Header Control Off
1 = Manual Enable
2 = Manual Speed Increase
3 = Manual Speed Decrease |
Header
E01 |
143 |
_ _ _ n |
nnnn |
DISPLAY: Failure overriding modes. This number is the sum of all failure modes existing at once. |
0 = Normal
1 = Shut off raise/lower valves due to valve driver problems
2 = Shut off tilt valves
4 = No Header Height Resume
8 = No Height Sensing, Height Float or Height Resume
16 = No Height Sensing
32 = No Height Float
64 = No Automatic Header Control
128 = No Automatic Header Control with Noncontacting (ultrasonic) sensors
256 = No Reel Resume Raise/Lower for Header Activation Button 1
512 = No Reel Resume Fore/Aft for Header Activation Button 1
1024 = No Reel Resume Raise/Lower for Header Activation Button 2
2048 = No Reel Resume Fore/Aft for Header Activation Button 2
4096 = No Reel Resume Raise/Lower for Header Activation Button 3
8192 = No Reel Resume Fore/Aft for Header Activation Button 3 |
Header
E01 |
144 |
_ _ _ _ |
_ nnn |
DISPLAY: Feederhouse position command |
Command by controller
Range = 0 - 127 |
Header
E01 |
145 |
_ _ _ _ |
_ nnn |
DISPLAY: Position set point |
Set by rotating Height Control Encoder
Range = 0 - 127 |
Header
E01 |
146 |
_ _ _ _ |
_ nnn |
DISPLAY: Feederhouse position |
Input from Height Resume Sensor
Range = 0 - 127 |