CAUTION: Engine must be off and key removed.

Beater wings can be replaced without removing beater from combine.

Replace beater wings in a set of two and opposite of each other on the beater. This keeps correct balance.

NOTE: If beater is removed from combine, or has loosened clamp cap screws, tighten clamp cap screws through access hole before torquing wing cap screws.

Remove hardware holding wing and remove wing.

Replace wing and torque cap screws to specification.

Specification

IMPORTANT: Wings must clear seals. Adjust if needed.

AG,OUZXMAY,346 -19-27NOV99-1/1