| Control Unit |
Add. |
Middle Line |
Lower Line |
Description |
Details |
Right
E02 |
33 |
_ _ _ _ |
nnnn |
DISPLAY: Left Separator Sensor strike count |
Entering the diagnostic mode zeroes the counts at addresses 030, 031, 032, and 033. Strikes on each Visiontrak sensor are counted. This address displays the Left Separator Sensor strike count. |
Right
E02 |
50 |
_ _ _ _ |
xxx1 |
DISPLAY: Header Engaged - CAN Message from Armrest Control Unit |
1 = CAN Bus message received that switch is pushed
0 = no message received or message received that switch is released |
Right
E02 |
60 |
nnnn |
_ _ _ _ |
DISPLAY: Main Gearcase Oil Temperature |
Temperature shown in degrees Centigrade |
Right
E02 |
61 |
nnnn |
_ _ _ _ |
DISPLAY: Hydraulic Oil Temperature |
Temperature shown in degrees Centigrade |
Right
E02 |
62 |
_ _ _ _ |
_ nnn |
DISPLAY: Fuel Level |
Shown as percent of full tank
0 = empty
100 = full |
Right
E02 |
63 |
_ _ _ _ |
nn.nn |
DISPLAY: Chopper Vane Angle |
Shown as degrees |
Right
E02 |
100 |
_ _ _ _ |
_ _ nn |
DISPLAY/MODIFY: Grain Loss Calibration Value |
Increase number to lower system sensitivity to loss. Decrease number to raise system sensitivity to loss.
Range = 0 - 99
Default = 25 |
Right
E02 |
101 |
_ _ _ _ |
_ _ _ n |
DISPLAY/MODIFY: Seed Size |
1 = small seed
2 = medium seed
3 = large seed |
Right
E02 |
102 |
_ _ _ _ |
_ _ _ n |
DISPLAY/MODIFY: Shoe Display |
0= Off
1 = left and right sensors are averaged
2 = left and right sensors are shown independently |
Right
E02 |
103 |
_ _ _ _ |
_ _ _ n |
DISPLAY/MODIFY: Separator Display |
0= Off
1 = left and right sensors are averaged
2 = left and right sensors are shown independently |
Right
E02 |
104 |
_ _ _ _ |
_ nnn |
DISPLAY/MODIFY: Shoe offset |
Increase number to lower displayed level of shoe loss. Decrease number to raise displayed level of shoe loss.
Range = 50 - 250
Combine - Default = 40 |